Difference between revisions of "Jointer"

From i3Detroit
Jump to: navigation, search
m (Put into format for template)
(Update + photo for the new jointer.)
Line 1: Line 1:
 
{{Equipment  
 
{{Equipment  
 
| Name = Jointer
 
| Name = Jointer
| Intro = The status of the jointer in the Wood Shop is in flux. The current jointer, which was made by Delta, has limited table adjustments by design. This would be fine if the infeed and outfeed tables were aligned, but they are not, and no practical way has been found to align them. As a result, a board fed through this jointer gets a curved edge rather than the straight edge needed for quality wood working. Plans are being made to replace the current jointer with a used model equipped with tables that can be aligned.
+
| Intro = The jointer in the Wood Shop is currently being set up.  
| Owner = Nick Britsky
+
| Owner = TBD, best contact person is Dave Alvarez
| StorageLocation = Tell people where to find it, and where to put it away.
+
| StorageLocation = The jointer should be stored in the wood shop. It is on a wheeled base so it can be rolled out to provide clearance for working with long boards.
 
| MakeModel = Acme CNC Yak Shaver - Model 5000 deluxe
 
| MakeModel = Acme CNC Yak Shaver - Model 5000 deluxe
 
| PartNumber =  
 
| PartNumber =  
 
| Documents = Link(s) to on-line documentation
 
| Documents = Link(s) to on-line documentation
| LooksLike = The jointer is currently disassembled:
+
| LooksLike = [[File:jointer.jpg|jointer photo]]
[[File:PhotoNeeded.png|100px]]
+
 
| Rules =
 
| Rules =
 
Put the rules that govern the use of this tool here.
 
Put the rules that govern the use of this tool here.

Revision as of 17:17, 1 October 2011


Jointer

The jointer in the Wood Shop is currently being set up.

Basic Info

  • Ownership: TBD, best contact person is Dave Alvarez
  • Location: The jointer should be stored in the wood shop. It is on a wheeled base so it can be rolled out to provide clearance for working with long boards.
  • What it looks like:

jointer photo

Manufacturer Information

  • Make/Model: Acme CNC Yak Shaver - Model 5000 deluxe
  • Part Number:

Documentation

not specified

Rules

Put the rules that govern the use of this tool here.

  • You can use any wiki formatting that you wish:
  • Like a bulleted list

Instructions

Set the cutting depth

The depth adjustment ...

Turn it On

The power switch is located ...

Turn it Off

The power switch is located ...

Other References

not specified

Maintenance

Does this thing need it's oil changed every 30 cycles? People need to know!

Things that Need to be Done

What problems does this thing have, or are there improvements that would make it better.

FAQs

  1. What is a jointer? Wikipedia has an excellent article on the Jointer.