Torqcut Start-up procedure
Bridgeport CNC Mill
Starting point for information related to the Bridgeport Torq-Cut 22 CNC milling machine. Very much a work in progress.
- Power up CNC mill with power switch on back panel. Clockwise is "on", counterclockwise is "off".
Main power switch in the "on" position.
Main power switch in the "off" position.
The CNC mill requires compressed air so the shop air compressor has to be running.
If no one else needs compressed air, don't forget to turn off the compressor after you're done. There's a leak somewhere in the system.
- Valve to shop compressed air at CNC mill.
Compressed air valve closed.
- Lift red air valve on CNC
You'll find the machine's air valve on the left side of the mill. Just raise it.
Machine air valve in the closed - down - position
Machine air valve in the open - up - position
Next thing you want to do before you start using the mill is check that its fluid levels are where they're supposed to be. The first thing to check is the lubricant level.
There's a level marked on the duct tape.
If the lubricant level's where it's supposed to be then check the coolant level.
There are filter screens on both sides of the coolant tank that can be removed to check coolant level.
The screens have handles but they tend to be pretty grimy so be warned.