|File:Link(s) to picture(s) of it|
|Storage Location||Miscellaneous supply shelf, NW corner|
|Documentation||Link(s) to on-line documentation|
|Other References|| Hacks wiki:
Workflow for 3d models, mentions craft robo but should work for SCAL or MTC too: http://digitprop.com/2011/05/from-blender-to-pepakura-to-corel-draw-to-craftrobo/
Open-source cutter driver: http://sourceforge.net/projects/licut/
If/when it breaks, we'll need this info: http://everhack.blog.atxhackerspace.org/2012/02/08/cricut-repair-info/
ATX Hackerspace has a cricut and lots of info here: http://atxhackerspace.org/wiki/Cricut
Like a miniature vinyl cutter, but for paper. Allows cutting of arbitrary shapes when used with special software on Craft Room laptop; otherwise, requires special cartridges with pre-loaded designs. Manual in craft room.
Put the rules that govern the use of this tool here.
- Who is allowed to use it?
- Is there any traning required before use?
You can write the instructions here. Or maybe add a link to another page or the user's manual.