View source for Cyclonic Dust Collection System

{{Equipment
|Name=Cyclonic Dust Collection System
|Zone=Wood Shop
|LooksLike=cyclonicdustcollection.jpg
|Owner=i3Detroit
|MakeModel=TBD
|Date=2011-07
|DateDeparted=2021-09
|StorageLocation=This system is located at the north end of the wood shop.
|Authorization Required=No
|Status=Departed
|Value=650
|Documentation=*
|OtherReferences=Estimated Characteristics 10in input duct, 4,000 cfm, Peak material 500 lbs/hr, density of wood chips 17lbs/cu ft*
|Intro=For collecting dust from the wood shop.
*Main Motor Baldor
*hp=7.5, Voltage 208-230/460, Amps 21-18.8/9.4, RPM= 3450, 3 phase, 60 HZ, Service F. 1.15
* Rotary Air Lock is Tice Model VJ10x8, S/N 36299-C1127, chain driven by:
* Motor A.O. Smith Model HF27034N, 115V ac, 1 P, 3/4hp 1700 rpm with gear box
|Rules=* Use with wood dust only, please!
* Turn on when using Table saw, Miter saw, Bandsaw, Sander.
* The ductwork is permanently connected to the table saw and miter saw.
* Open slide gates when using the bandsaw or sander and close when done.
* Connect with hose to planer and jointer when using these tools
|Instructions=* The power switch is on ductwork down drop between the table saw and the chop saw. It is held in place with a magnet.
* Check to be sure dust/chips are falling into dust bin under airlock. If not, contact coordinator as there may be a clog.
|MaintenanceInfo=Check Chip bin after each use, empty when 1/2 to 3/4 full, use 55gal trash bags located near machine
|FAQs=*When the barrels under the sleeves feel full, empty them into the dumpster. 
*Replace the plastic bag with a new one of the right size. 
*
|ToDos=purchased use New Rotary AirLock*
|Maintenance Info=*
}}