Cyclonic Dust Collection System

From i3Detroit
Jump to: navigation, search

Cyclonic Dust Collection System
Name Cyclonic Dust Collection System
Zone Wood Shop
Owner i3Detroit
Make Model TBD
Part Number
Date Acquired
Storage Location This system is located at the north end of the wood shop.
Authorization Required No
Status Running
Documentation *
Other References *


For collecting dust from the wood shop.

  • Main Motor Name plate info
  • hp=7.5, Voltage 208-230/460, Amps 21-18.8/9.4, RPM= 3450, 3 phase, 60 HZ, Service F. 1.15
  • Rotory Air Lock Motor info
  • hp=


  • Use with wood dust only, please!
  • Turn on when using Table saw, Miter saw, Bandsaw, Sander.
  • The ductwork is permanently connected to the table saw and miter saw.
  • Open slide gates when using the bandsaw or sander and close when done.
  • Connect with hose to planer and jointer when using these tools


  • The power switch is on ductwork down drop between the table saw and the chop saw. It is held in place with a magnet.

Maintenance Info