Difference between revisions of "MIG Welder - Hobart RC250"

From i3Detroit
Jump to: navigation, search
(Maintenance and howtos)
Line 41: Line 41:
 
* [http://www.gowelding.org/Techniques_MIG_Welding.html Techniques]
 
* [http://www.gowelding.org/Techniques_MIG_Welding.html Techniques]
 
* [http://www.hotrod.com/techarticles/general/hrdp_1107_mig_welding_guide/ Read This!]
 
* [http://www.hotrod.com/techarticles/general/hrdp_1107_mig_welding_guide/ Read This!]
 +
 +
| FAQs =
 +
*
 
}}
 
}}
  
 
[[Category:Welding Shop]]
 
[[Category:Welding Shop]]

Revision as of 23:11, 7 January 2014

MIG Welder - Hobart RC250
"File:Hobart_RC-250.jpg | thumb" cannot be used as a page name in this wiki. [[Image:
Hobart RC-250.jpg
|175px| ]]
Name Hobart Mig Welder
Zone
Owner i3 Detroit
Make Model Hobart RC-250
Part Number [[EquipNumber::5719B-1
Hobart RC-250 Name plate.jpg
]]
Date Acquired
Storage Location Welding Area, against the wall.
Authorization Required
Status
Value
Documentation *Hobart MIG Welder Manual
Other References * Welder consumables are on this list: Welding Shop Consumables

Intro

Rules

Be Trained!! This machine takes some playing with to get the hang of.

Instructions

  • Turn on the Gas bottle at the wall rack. Remember that the seal system for inert gas only completely seals the stem at full closed and full open. Turn the knob in the desired direction until it stops. When the "Purge" switch is pressed, you can adjust the argon/co2 flow (watch the red ball in the vertical glass tube).
  • Check the power disconnect switch on on the wall. (BusBar #1 Hobart Welder) Is it turned on?
  • Adjust current/wire speed, corse voltage and fine (start low so you don't fuse the tip shut, if you do.. replace it!)
  • Wire not feeding? Check the wire switch is set to "fwd"
  • start 1/4-1/2" away from material. (too close and you'll fuse the tip shut)

Maintenance Info

  • Adjusted machine settings in control box. Seemed to help with tip fusing issue.

FAQ

ToDo