From i3Detroit
Revision as of 14:54, 17 September 2011 by Surferdudemi (Talk | contribs) (Put into format for template)

Jump to: navigation, search
"The jointer is currently disassembled:

[[File:PhotoNeeded.png|100px" cannot be used as a page name in this wiki. [[Image:The jointer is currently disassembled: PhotoNeeded.png|175px| ]]

Name Jointer
Owner Nick Britsky
Make Model Acme CNC Yak Shaver - Model 5000 deluxe
Part Number
Date Acquired
Storage Location Tell people where to find it, and where to put it away.
Authorization Required
Other References


The status of the jointer in the Wood Shop is in flux. The current jointer, which was made by Delta, has limited table adjustments by design. This would be fine if the infeed and outfeed tables were aligned, but they are not, and no practical way has been found to align them. As a result, a board fed through this jointer gets a curved edge rather than the straight edge needed for quality wood working. Plans are being made to replace the current jointer with a used model equipped with tables that can be aligned.


Put the rules that govern the use of this tool here.

  • You can use any wiki formatting that you wish:
  • Like a bulleted list


Set the cutting depth

The depth adjustment ...

Turn it On

The power switch is located ...

Turn it Off

The power switch is located ...

Maintenance Info

Does this thing need it's oil changed every 30 cycles? People need to know!


  1. What is a jointer? Wikipedia has an excellent article on the Jointer.


What problems does this thing have, or are there improvements that would make it better.