Jointer

From i3Detroit
Revision as of 22:17, 29 November 2013 by Djscholl (Talk | contribs) (Updated ownership and dust collection information)

Jump to: navigation, search
Jointer
"File:jointer.jpg|jointer photo" cannot be used as a page name in this wiki. [[Image:jointer photo|175px| ]]
Name Jointer
Zone
Owner i3 Detroit
Make Model Chiu Ting WJT-150 (6 inch jointer)
Part Number S/N 4932
Date Acquired
Storage Location The jointer should be stored in the Wood Shop. It is on a wheeled base so it can be rolled out to provide clearance for working with long boards.
Authorization Required
Status
Value
Documentation * Wikipedia has an excellent article on the Jointer.
Other References

Intro

A jointer is used to create a straight surface on a wooden board.

Rules

  • To prevent nicks on the blades, please check your board carefully and remove nails, screws, and any other metal bits.
  • Work with pure wood only, please! Masonite, for example, will quickly dull the blades. Even plywood, particleboard, MDF, and the like will shorten the blade life because of the glue content.

Instructions

Connect the Dust Collection

Connect the flexible hose from the big dust collector to the dust collection port on the left side of the base cabinet. Disconnect after use.

Set the cutting depth

The depth adjustment ...

Turn it On

The power switch is located on the front of the base.

Turn it Off

The power switch is located on the front of the base.

Maintenance Info

Two critical adjustments need to be maintained on the jointer. The infeed and outfeed tables need to be parallel to within 0.001 in. or so, and the blades need to be 0.001 in. higher than the outfeed table.

FAQ

ToDo