Difference between revisions of "Antenna Analyzer"

From i3Detroit
Jump to: navigation, search
Line 12: Line 12:
 
* Do not leave without charging if V<sub>batt</sub> drops below 13V.  V<sub>batt</sub> is displayed on the LCD at boot, and a charging cable is included in the box.   
 
* Do not leave without charging if V<sub>batt</sub> drops below 13V.  V<sub>batt</sub> is displayed on the LCD at boot, and a charging cable is included in the box.   
 
* Do not power on with UHF button depressed.  Press UHF button AFTER power up.  If you are surprised by this, you didn't read the manual.  Please do that.
 
* Do not power on with UHF button depressed.  Press UHF button AFTER power up.  If you are surprised by this, you didn't read the manual.  Please do that.
| Instructions = If you get strange results, try letting the unit warm up a bit.  Also, let me know, I'll reprioritize replacing the transistor.
+
| Instructions = If you get strange results, try letting the unit warm up a bit.  Also, let me know, I'll reprioritize replacing the transistor.  Also, as mentioned, read the manual and charge to a V<sub>batt</sub> of 13V when done please.
 
}}
 
}}
 
[[Category:Electronics Shop]]
 
[[Category:Electronics Shop]]

Revision as of 18:58, 26 December 2013

Antenna Analyzer
[[Image:Mfj269B.jpg|175px| ]]
Name MFJ 269B Antenna Analyzer
Zone
Owner [[EquipOwner::Brad Tarratt]]
Make Model MFJ 269B
Part Number
Date Acquired
Storage Location In the plastic box next to the amateur radio station in the e-room.
Authorization Required
Status
Value
Documentation Full documentation is included in the plastic box the unit is in. Or here.
Other References

Intro

This is the Antenna Analyzer in the e-room. In 2011 it exhibited some strange behavior when cold, but we haven't been able to reproduce this recently. We may replace a transistor in it at some point.

Rules

  • Read the manual before using
  • Do not remove from shop (parking lot okay)
  • Do not leave without charging if Vbatt drops below 13V. Vbatt is displayed on the LCD at boot, and a charging cable is included in the box.
  • Do not power on with UHF button depressed. Press UHF button AFTER power up. If you are surprised by this, you didn't read the manual. Please do that.

Instructions

If you get strange results, try letting the unit warm up a bit. Also, let me know, I'll reprioritize replacing the transistor. Also, as mentioned, read the manual and charge to a Vbatt of 13V when done please.

Maintenance Info

FAQ

ToDo