Property:TODO
Jump to navigation
Jump to search
H
Have fun with your new skill and make cool things. +
* Figure out if we need it
+
# Update Wiki pages for this page and for Training page as well as produce training videos.
+
*Source more dies
*Add a good pic to this page
*Add the manual or a link to it
*Maybe find some good videos and link them
+
Perform monthly checks and maintenance. +
Add instructions
Add picture
Pay Paul for his mom
Make a list of all accessories included +
Missing parts were purchased so machine could be used and have been tested. No other tasks due at this time. +
I
* Make a permanent home for the remote control
* Route VGA/Composite cables from the projector down behind the screen to the audio hookup location
* Add an HDMI adapter and chromecast
+
J
* Build Cabinet for Drill Press tools and accessories
+
Add outfield tables +
New bobbin winder.
Install manual knee lift to replace defective servo. +
K
Purchase new power pedal. Feet? What kind of plug is it? +
*get actual picture
*finish model number
*add maintenance info
*It's been so long, it needs oil points most likely and a test run
+
*List out what the stitches are.
*What bobbin class is it?
*Stitch #3 may not work.
*Stitch #4 may not work.
*Stitch #7 may not work.
+
Setup and get running. Looks like a washing machine. +
Get new belt +
Set up and get working. +
L
* Move the controller to the bottom of the cart
* Cable routing & cleanup
* Reinstall Force Sensor
* Install Force Sensor calibration file
* Install Force Sensor metal faceplate
* Create faceplate adapter to allow mounting original tools
+
;New cylinders to hold different lenses,
:...to make it easy and safe to change them without smudging or damage. Sector67 has indicated they may make some of these. (The existing cylinder has too narrow an opening for the lens that gives a long focal length. Its beam is so wide that it hits the lip and heats up the cylinder.)
;Payment-measuring timer.
:One way to do this would be to measure current to the machine and time how long it runs at laser-firing power. It would be good to put a button on the timer that would re-set it to zero.
:Another way, used at other spaces, is to use the "blow" output contact from the controller, which is meant to trigger the air-assist, in case bottled gas is being used for special cutting.
===Done===
;Payment box.
:Greg Smith made it.
;Laptop desk.
:Standing desk built by [[user:Dustinbikes|Dustin White]] & Ted Hansen.
;Aperture in the chassis, through which to thread the blue USB cable with a grommet.
:Instead, we discovered an exit under the machine and threaded it through that. [[user:Mattarnold|Matt Arnold]] used sugru on the side of the standing desk for a place to attach the end of the cable when unused. +