Shop Fox Resaw Bandsaw
| Shop Fox Resaw Bandsaw | |
|---|---|
| |
| Name | Shop Fox Resaw Bandsaw |
| Zone | Wood Shop
|
| Owner | i3Detroit |
| Make Model | Shop Fox W1729 |
| Part Number | |
| Date Acquired | 2/10/26 |
| Storage Location | |
| Authorization Required | No |
| Status | Running |
| Value | $900
|
| Documentation | Operations Manual
Specifications |
| Other References | |
Intro
Dedicated resaw bandsaw fitted with 1 inch 3TPI blade. Maximum 12 in resaw capacity.
Rules
Allowed adjustments for work piece being sawn include:
- Guide Post height,
- Table angle,
- Use of alternative fence attachments (e.g., high fence for tall resaws).
Other adjustments to guide positions, blade changes, are not allowed unless you are an authorized maintainer.
- Open blast gate and turn on dust collector. Close blast gate when done.
- For cutting wood or plastics, no metals
- Read, understand and follow the safety instructions found in the manual
- Keep fingers 3 inches from the blade
- Do not cut wood that is not flat on the bottom, use a jig
- Never clear small pieces while the blade is running
- Do not push work with your thumbs.
- Keep guards in place
- Do not force the tool, it will do a better job at the rates it is designed for
- Wear proper apparel, do not wear loose clothing or other items that may get caught. Wear protective hair covering to contain long hair.
- Always wear Safety glasses.
Instructions
- Refer to operations manual for instructions on rip cuts, cross cuts, resawing and other techniques
- Plan your cuts before making them
- Set Upper Blade guide assembly, raise or lower to just above the material being cut
- Feed material only into the blade DO NOT BACK UP MATERIAL with the machine running or the blade will come loose from the guides. stop it first.
- Feed work gently into the blade, do not force the work or bend the blade
- Both hands should be used to feed the wood, and placed on opposite sides of the blade
- A jig or clamp should be used to hold odd shaped or round pieces
- Make through cuts or release cuts, if needed predrill holes so that waste pieces can be removed
Maintenance Info
FAQ
ToDo