|Zone Name||Welding Area|
|Zone Slogan||"I'm a lame zone with no slogan"|
|Zone Coordinator(s)||Jody Raiford|
Welding is a great way to join and form metal. Welding use comes at some risk. Let's be careful out there.
- Eye protection. You must protect your eyes from the bright welding light. If you are TIG, MIG or Arc welding you should be wearing a welding helmet. If you are using oxygen/acetylene welding then you should be wearing a pair of gas welding goggles or the dark face shield.
- Consider the eye protection of others around you. Will they get flashed by your welding arc? Use the welding safety screens to protect others in the shop.
- Proper clothing. Shorts and T-shirt won't do. Arc welding gives off extremely bright UV light, and you will become badly sunburned in no time. Best is long sleeve cotton clothing and long cotton pants (tight knit lightweight wool is actually the "best", but hard to find). Polyester clothing will melt easily and should never be worn by anyone welding.
- Proper footwear. Leather closed toe shoes should be worn. It doesn't take long for a small hot bead of metal to burn right through the top of your canvas tennis shoes. Also consider wearing boots instead of low cut shoes. Think what will happen if a drop of molten metal gets inside your shoe. Ouch.
- Wear welding gloves to protect your hands. Mechanics' gloves tend to have plastic or rubber which will melt while welding.
- Don't forget that it takes time for hot welded metal to cool. Use pliers to lift work off of the table. Don't leave hot work where an innocent bystander could become burned. If you aren't sure about the temperature of a piece, assume it's hot until proven otherwise.
- Ventilation. Don't breath the fumes, some/most metals and filler material contains toxic fumes.
- Quick.. where is the nearest fire extinguisher?
- "Gas First" : Close all gas bottles
- "Cables off the floor" : Coil all cables/cords (no sharp kinks) and hang them so they are off the floor
- Put tools away
- Put material away: Usable Scrap under table or in bins, project material in personal storage (mark it or lose it!)
- Turn off disconnects on east wall "BusBar #1 MIG Welders, BusBar #2 TIG Welders)
- Clear table, Grind spatter, sweep. (Leave it better than you found it)
- Turn off over head lights (Orange switch on east wall)
Table of Equipment
|MIG Welder - Miller Millermatic 212||Yes||i3Detroit||Running|
|TIG Welder - Miller Dynasty 200||Yes||Jim Kemp||Running|
|Handheld Plasma Cutter||Yes||i3Detroit||Running|
|Rolling Toolbox||No||Jody Raiford||Running|
|Stick Welder 1||No||Steve F00f Nowicki||Running|
|Stick Welder 2||No||Ted Hansen||Running|
|Weld Zone Light Button||No||i3Detroit||Running|
Learn to MIG
Learn to TIG
Pages in category "Welding Area"
The following 16 pages are in this category, out of 16 total.